After hammer slice became blunt, it could be changed into another side. YONGLI most hammer mill uses single hole slice, when both angles blunt, all the slices should be replaced to ensure the balance of motor.
After the removal of the hammer piece (one of a pin), check the pin shaft and wear-resistant plate, hammer piece between the ring, pin and other parts of the ring, and other internal parts, if these parts are worn, it is necessary to change slice;
YONGLI mill installation screen plate, mesh belt burr side should be smooth, outward, screen and screen frame to fit tightly;
After the end of each shift, should will both inside and outside grinder clean, remove the dirt, so as to avoid the machine rusty, screen blinding, bearing into dust and dirt;
Regular inspection, cleaning and lubrication of bearings, bearings every running 300-400 hours, should add 80 grams of grease;
It is found that the machine parts have serious wear and damage, should be repaired in time to replace, after the repair of the rotor should take balance test.
Web: www.yongli-machine.com
Contact: jessica@yongli-machine.com
评论
发表评论