Yongli wood chipper in operation, hand pumps and two stop valves should be closed, from the accumulator and fuel oil.
The accumulator tank must be filled with nitrogen gas, which must not be filled with oxygen or air. Filled with oxygen will cause an explosion, filling the air so that the tank is easy to aging. According to the specification of the operation manual, the accumulator is filled with nitrogen pressure. Nitrogen should be added when the nitrogen pressure is insufficient. Can be used to check the pressure and inflation with random. When the gas cylinder is directly inflated, the switch on the nitrogen bottle should be opened slowly so as to avoid the damage of the energy storage tank with high pressure nitrogen. Only if the oil pressure is released in the accumulator, can the accumulator be removed.
Before the operation of the chip, the large oil cylinder should be filled with a certain amount of oil pressure, oil pressure is generally higher than the pressure 0.3-0.6MPa. According to the feeding of different raw materials, adjust the filling of the oil pressure. The cutting path of wood or aniseed, oil can be bigger. On the other hand, cutting small material, skin, small oil. But no matter what kind of situation, the oil pressure must be higher than the pressure, the accumulator can play a buffer role.
When installing and debugging the slicing machine, we should adjust the one-way throttle valve, so that the speed of the pendulum is moderate and there is no blocking phenomenon.
Drum slicer cutting raw materials to adapt to a wide range. In order to adapt to a variety of materials, such as bending of branches, the edge of the plate and a bundle of strip material, so drum slicer into discharge hole size larger. It cannot be mistaken for the size of the feed inlet, it can be cut into many large diameter wood, which can cause the machine to overload and damage the knife and the machine. Slicer manual provisions allow maximum cross-sectional area of cutting raw material and converted into single wood diameter. In order to extend the service life of the drum slicer and improve the quality of slice, close to the maximum section, cutting length should not be more than 2m, the moisture content of raw material for cutting rate should be at about 65%.
Contact: jessica@yongli-machine.com
评论
发表评论